How to make resin drawer knobs?
Here are some steps to help you get started:
Materials needed
- Resin
- Mixing cups and sticks
- Silicone mold
- Drawer knob bases
- Adhesive
Steps
- Prepare your workspace by covering it with a silicone mat, wax paper, or plastic sheeting.
- Mix the resin according to the manufacturer's instructions.
- Pour the resin into the silicone mold, making sure to fill it completely.
- Place the drawer knob base in the center of the mold.
- Use a heat gun, hair dryer, or butane torch to remove any bubbles that may have formed.
- Allow the resin to cure according to the manufacturer's instructions.
- Once the resin is cured, remove it from the mold.
- Use adhesive to attach the drawer knob base to the back of the resin piece.
- Your resin drawer knob is now ready to use!
Variations
There are many variations you can try when making resin drawer knobs. Here are a few ideas to get you started:Shimmering drawer knobs
If you want to add a touch of shimmer to your drawer knobs, you can try using glitter. Here are the steps:- Prepare your workspace by covering it with a silicone mat, wax paper, or plastic sheeting.
- Mix the resin according to the manufacturer's instructions.
- Add a small amount of glitter to the resin and mix well.
- Pour the resin into the silicone mold, making sure to fill it completely.
- Place the drawer knob base in the center of the mold.
- Use a heat gun, hair dryer, or butane torch to remove any bubbles that may have formed.
- Allow the resin to cure according to the manufacturer's instructions.
- Once the resin is cured, remove it from the mold.
- Use adhesive to attach the drawer knob base to the back of the resin piece.
- Your shimmering resin drawer knob is now ready to use!
Pressed leaf drawer knobs
If you want to add a touch of nature to your drawer knobs, you can try using pressed leaves. Here are the steps:- Prepare your workspace by covering it with a silicone mat, wax paper, or plastic sheeting.
- Press leaves between two sheets of wax paper and a heavy book for several days until they are completely dry.
- Mix the resin according to the manufacturer's instructions.
- Place the pressed leaves in the silicone mold.
- Pour the resin over the leaves, making sure to cover them completely.
- Place the drawer knob base in the center of the mold.
- Use a heat gun, hair dryer, or butane torch to remove any bubbles that may have formed.
- Allow the resin to cure according to the manufacturer's instructions.
- Once the resin is cured, remove it from the mold.
- Use adhesive to attach the drawer knob base to the back of the resin piece.
- Your pressed leaf resin drawer knob is now ready to use!
0 Comments